Getting it right

McCalls 6028 has taken me a while to make this fit me. There’s a satin/lace dress I’m planning on making so I’ve tested this pattern three times because I want to ‘get it right’.

Version 1: Check cotton fabric

This version is a size 14 based on my current measurements and I used a green/white check cotton to test out my initial adjustments.
Forward shoulder adjustment and sway back adjustment were the two changes I made on the tissue. I did drop the bust apex by 2.5cm.
Once I made up the dress, it was too big from the waist up.

Currently unpicked and ready to be resized.

This print was a piece I bought in Portland 4 years ago so I was eager to see if this fabric was still a goer. I also practiced sewing in an invisible zipper on this finer cotton fabric.

Conclusion: Go down a size and raise the hemline.

Version 2: Heavy slub cotton fabric

This version is a size 12 using a heavier cotton fabric with the new adjustments from #1.
The bodice back bodice needed taking in below the shoulders and the front bodice also needed taking in above the waist.

You can just see the piping added along the front seam lines.

Once I tweaked the seams, I overlocked them. There wasn’t enough fabric for the facings so I used bias binding to finish the neckline and hem.

The back was very simple to construct – even the invisible zipper.

This is already a handy work dress.

This cotton fabric was a Spotlight find from a few years ago. I added a strange trim that I bought online to practice piping. This isn’t my best work so I’ll have to practice some more…

I’ve used the piping feature on the sleeve hem – again this is hard to see.

The invisible zipper sits really neatly on this fabric. I unpicked a RTW skirt and found the invisible zipper had two sets of stitching – one close to the zipper teeth and the other mid way along the zipper tape.

Conclusion: Try it again with the facing this time.

Version 3: Printed ponte knit

Size 12 using the facing pieces on ponte and making the sleeve ‘winter’ length.

The facing pieces added a bit of bulk and after wearing the dress, I’ve added a fine knit from the facing to skirt length to avoid the fabric clinging to me.

This pic shows the grey knit lining I’ve used inside the dress. This stops it from clinging.

I bought this printed ponte knit from Minerva Crafts UK when I visited their store last year. Sam used the same printed ponte for her separates last year.

Everything lined up along the back.

The invisible zipper sat nicely on this version. I used a dark green thread so that I could see the thread when I had to unpick the seams.

Here’s a close up of the trim I added along the front seaming.

The sleeve pattern doesn’t extend to the wrist so I lengthened the pattern and rechecked the width of the sleeve. It took me a couple of goes at slimming the sleeves in. Otherwise I would have drowned in the print and I do like this print.

There are a lot of ways this dress can be made up and I think by trialling the pattern for fit, I’ve discovered a few ways this dress can become a favourite.

Here’s how this works together with my Quart coat for Winter.I’m hoping my chances of the satin/lace version works. I still need to adjust the neckline for the style that I want.
More soon.
Follow(function(d, s, id) {var js, fjs = d.getElementsByTagName(s)[0];if (d.getElementById(id)) return;js = d.createElement(s);js.id = id;js.src = “https://www.bloglovin.com/widget/js/loader.js?v=1”;fjs.parentNode.insertBefore(js, fjs);}(document, “script”, “bloglovin-sdk”))

20 comments

Thanks Faye.

Getting it right

Version 1: Check cotton fabric

Version 2: Heavy slub cotton fabric

Version 3: Printed ponte knit

Share this:

Related

20 comments

Leave a comment Cancel reply